AnyTone cellular amplifiers best price

How It Works

There are a lot of reasons for bad or low signals that your mobile phone accepts. One of the most spread are usually caused with the blind zones in the cell coverage, with the thick walls in the buildings, their remote location from the mobile base station, the location of the area below the ground, where the radio waves from a cell phone base station cannot reach the mobile phone.

Fortunately, we have a solution to all this problems caused with low and bad signals. Our cellular amplifiers successfully overcome them. They receive even a weak signal from the outside, and then amplify it into a strong signal inside the building, thus making your conversations over the phone pleasant and easy.

All our cellular amplifiers are designed to fulfill the idea of one and main principle: to fill the areas with the weak or bad signal and to amplify these low signals in order to provide you with the communication suitable for you.

Steps that describe the work of our cellular amplifiers.

Step 1. The outside antenna receives the signal from the nearest mobile base station.

Step 2. The outside antenna sends the received signal through the coax cable to the installed cellular amplifier.

Step3. The cell amplifier accepts the low signal and improves it.

Step 4. The improved signal goes to the inside antenna through the connection coax cable.

Step 5. The inside antenna send the improved good signal to your mobile phone.

All our cellular amplifiers work at full duplex. It means that they not only receive the weak signal from the mobile base station and then divert to mobile phone after amplifier. They also receive the signal from your mobile phone and then send it to the mobile base station.

If you are ready to order, please check our list of cell phone repeaters. If you have any questions, please visit our F.A.Q. page or contact us.

Also: Check out cell phone repeaters for big buildings.